Command Manual – QoS
H3C S7500E Series Ethernet Switches Chapter 2 QoS Policy Configuration Commands
2-23
Parameters
name policy-name: Specifies to display the information about the VLAN policy with the
specified name.
vlan vlan-id: Specifies to display the information about the VLAN policy applied to the
specified VLAN.
slot-id: Specifies to display the information about the VLAN policies applied to VLANs
on the board seated in the specific slot. If the slot-id argument is not specified, this
command displays the information about the VLAN policies applied to the SRPU.
Description
Use the display qos vlan-policy command to display the information about VLAN
policies.
If the vlan-id argument is not specified, the information about all the VLAN policies will
be displayed.
Examples
# Display the information about the VLAN policy named test.
<Sysname> display qos vlan-policy name test
Policy test
Vlan 300: inbound
Table 2-8 Description on the fields of the display qos vlan-policy command
Field Description
Policy Name of the VLAN policy
Vlan 300 ID of the VLAN where the VLAN policy is applied
inbound VLAN policy is applied in the inbound direction of the VLAN.
# Display the information about the VLAN policy applied to VLAN 300.
<Sysname> display qos vlan-policy vlan 300
Vlan 300
Direction: Inbound
Policy: test
Classifier: test
Operator: AND
Rule(s) : If-match customer-vlan-id 3
Behavior: test
To Next Page
Loading...
Need help?
General
