H3C S7500E Series Command Manual

Command Manual – SNMP-RMON
H3C S7500E Series Ethernet Switches Chapter 1 SNMP Configuration Commands
1-12
1.1.11 snmp-agent
Syntax
snmp-agent
undo snmp-agent
View
System view
Parameters
None
Description
Use the snmp-agent command to enable SNMP agent.
Use the undo snmp-agent command to disable SNMP agent.
By default, SNMP agent is disabled.
Examples
# Disable the current SNMP agent.
<Sysname> system-view
[Sysname] undo snmp-agent
1.1.12 snmp-agent community
Syntax
snmp-agent community { read | write } community-name [ acl acl-number | mib-view
view-name ] *
undo snmp-agent community community-name
View
System view
Parameters
read: Indicates that the community has read only access right to the MIB objects, that is,
the community can only inquire MIB information.
write: Indicates that the community has read and write access right to the MIB objects,
that is, the community can configure MIB information.
community-name: Community name, a string of 1 to 32 characters.
acl acl-number: ACL for the community name, with acl-number indicating the ACL
number, in the range 2,000 to 2,999.

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English