Command Manual – File System Management
H3C S7500E Series Ethernet Switches Chapter 1 File System Management Commands
1-12
The directory must be an empty one. If it is not, first delete all files and subdirectory
under it with the delete command.
Examples
# Remove directory mydir.
<Sysname> rmdir mydir
Rmdir flash:/mydir?[Y/N]:y
...
%Removed directory flash:/mydir.
1.1.17 umount
Syntax
umount device
View
User view
Parameters
device: Storage device name (for example flash or cf).
Description
Use the umount command to unmount a hot swappable storage device, such as a CF
card or a USB device, excluding Flash. This command is effective only when the device
is in mounted state.
By default, a storage device is in the mounted state, that is, you can use it without
mounting it.
Note that:
z Do not remove the storage device or swap the board when mounting or
unmounting the device, or when you are processing files on the storage device.
Otherwise, the file system could be damaged.
z When a storage device is connected to a low version system, the system may not
be able to recognize the device automatically, you need to use the mount
command for the storage device to function normally.
z Before removing a mounted storage device from the system, you should first
unmount it to avoid damaging the device. By default, a storage device is in the
mounted state. You can use it without mounting it.
Related commands: mount.
Examples
# Unmount a CF card of the main board
To Next Page
Loading...
Need help?
General
