H3C S7500E Series - Page 1275

Command Manual – File System Management
H3C S7500E Series Ethernet Switches Chapter 2 FTP Configuration Commands
2-9
Trying 192.168.1.46 ...
Press CTRL+K to abort
Connected to 192.168.1.46.
220 FTP service ready.
User(192.168.1.46:(none)):ftp
331 Password required for ftp.
Password:
230 User logged in.
[ftp]undo passive
[ftp] debugging
[ftp] get sample.file
---> PORT 192,168,1,44,4,21
200 Port command okay.
The parsed reply is 200
---> RETR sample.file
150 Opening ASCII mode data connection for /sample.file.
The parsed reply is 150
FTPC: File transfer started with the signal light turned on.
FTPC: File transfer completed with the signal light turned off.
.226 Transfer complete.
FTP: 3304 byte(s) received in 4.889 second(s), 675.00 byte(s)/sec.
[ftp]
Table 2-2 debugging command output description
Field Description
The parsed reply is
The received reply code, which is
defined in RFC 959.
FTPC: File transfer started with the
signal light turned on.
File transfer starts, and the signal light is
turned on.
FTPC: File transfer completed with the
signal light turned off.
File transfer is completed, and the signal
light is turned off.
2.2.8 delete
Syntax
delete remotefile