H3C S7500E Series Command Manual

Command Manual – Port Correlation Configuration
H3C S7500E Series Ethernet Switches
Chapter 1 Ethernet Port Configuration
Commands
1-11
Description
Use the display storm-constrain command to display the information about storm
constrain.
If you provide no argument or keyword, this command displays the information about
storm constrain for all types of packets on all the ports.
Examples
# Display the information about storm constrain for all types of packets on all the ports.
<Sysname> display storm-constrain
Flow Statistic Interval: 10(second)
PortName StormType LowerLimit UpperLimit Ctr-mode Status Trap Log Swi-num
--------------------------------------------------------------------------
Eth2/0/1 broadcast 50 200 N/A normal on on 0
Table 1-6 Description on the fields of the display storm-constrain command
Field Description
Flow Statistic Interval Interval for generating storm constrain statistics
PortName Simplified port index
StormType
Type of the packets for which storm constrain function is
enabled, which can be broadcast (for broadcast packets),
multicast (for multicast packets)
LowerLimit Lower threshold (in pps)
UpperLimit Upper threshold (in pps)
Ctr-mode
Action to be taken when the upper threshold is reached,
which can be block, shutdown, and N/A.
Status
Port state, which can be normal (indicating the port
operates properly), control (indicating the port is blocked
or shut down).
Trap
State of trap messages sending. “on” indicates trap
message sending is enabled; “off” indicates trap
message sending is disabled.
Log
State of log sending. “on” indicates log sending is
enabled; “off” indicates log sending is disabled.
Swi-num
Number of the forwarding state switching.
This field is numbered modulo 65,536.

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English