H3C S7500E Series - Page 1475

Command Manual – PoE
H3C S7500E Series Ethernet Switches Chapter 1 PoE Configuration Commands
1-12
View
Any view
Parameters
pse-id: PSE ID. You can use the display poe device command to view the mapping
between PSE ID and slot. If you enter a PSE ID, the information of the PSE is displayed.
Otherwise, the information of all PSEs on the device is displayed.
Description
Use the display poe pse command to display the information of the specified PSE.
Examples
# Display the information of PSE 7.
<Sysname> display poe pse 7
PSE ID : 7
PSE Slot No : 0
PSE SubSlot No : 0
PSE Model : LSQ1FV48SA
PSE Power Enabled : enable
PSE Power Preempted : no
PSE Power Priority : low
PSE Current Power : 9 W
PSE Average Power : 8 W
PSE Peak Power : 11 W
PSE Max Power : 100 W
PSE Remaining Guaranteed : 100 W
PSE CPLD Version : -
PSE Software Version : 503
PSE Hardware Version : 1
PSE Legacy Detection : enable
PSE Utilization-threshold : 80
PSE Pse-policy Mode : priority
PSE Pd-policy Mode : priority
PSE PD Disconnect Detect Mode : AC
Table 1-6 Description on the fields of the display poe pse command
Field Description
PSE ID ID of the PSE
PSE Slot No Slot number of the PSE
PSE Model Model of the PSE module