H3C S7500E Series Command Manual

Command Manual – RRPP
H3C S7500E Series Ethernet Switches Chapter 1 RRPP Configuration Commands
1-4
ring-id: RRPP ring ID, in the range 1 to 64.
Description
Use the display rrpp statistics command to display RRPP message statistics.
Note that:
z If you have specified an RRPP ring ID in the command, RRPP message statistics
of the specified RRPP ring in the specified RRPP domain on the current device
appears. Otherwise, RRPP message statistics of all RRPP rings in the specified
RRPP domain appears.
z If some port belongs to more than one ring, its packets are taken statistics based
on the rings. You will view the statistics of the port under the current ring.
z When a ring transits from inactive status into active status, its packets will be taken
statistics again.
Related commands: reset rrpp statistics.
Examples
# Display RRPP message statistics of ring 1 in RRPP domain 1.
<Sysname> display rrpp statistics domain 1 ring 1
Ring ID : 1
Ring Level : 1
Node Mode : Master
Active Status : Yes
Primary port : GigabitEthernet3/0/1
Packet Link Common Complete Packet
Direct Health Down Flush FDB Flush FDB Total
------------------------------------------------------------------------
Send 16424 0 0 1 16425
Rcv 0 0 0 0 0
Secondary port: GigabitEthernet3/0/2
Packet Link Common Complete Packet
Direct Health Down Flush FDB Flush FDB Total
------------------------------------------------------------------------
Send 0 0 0 0 0
Rcv 16378 0 0 1 16379
# Display RRPP message statistics of RRPP domain 2.
<Sysname> display rrpp statistics domain 2
Ring ID : 1
Ring Level : 0
Node Mode : Master
Active Status : Yes
Primary port : GigabitEthernet3/0/3

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English