Command Manual – IP Routing Overview
H3C S7500E Series Ethernet Switches Chapter 1 Routing Overview Commands
1-25
Description
Use the display ipv6 routing-table verbose command to display detailed information
about all active and inactive routes, including the statistics of the entire routing table
and information for each route.
Examples
# Display detailed information about all active and inactive routes.
<Sysname> display ipv6 routing-table verbose
Routing Table :
Destinations : 1 Routes : 1
Destination : ::1 PrefixLength : 128
NextHop : ::1 Preference : 0
RelayNextHop : :: Tag : 0H
Neighbour : :: ProcessID : 0
Interface : InLoopBack0 Protocol : Direct
State : Active NoAdv Cost : 0
Tunnel ID : 0x0 Label : NULL
Age : 22161sec
Table 1-11 Description on the fields of the display ipv6 routing-table verbose
command
Field Description
Destination Destination IPv6 address
PrefixLength Prefix length of the address
Nexthop Next hop
Preference Routing preference
RelayNextHop Relay next hop
Tag Tag of the route
Neighbour Neighbor address
ProcessID Process ID
Interface Outbound interface
Protocol Routing protocol
State
State of the route, Active, Inactive, Adv (advertised), or
NoAdv (not advertised)
Cost Cost of the route
Tunnel ID Tunnel ID
To Next Page
Loading...
Need help?
General
