H3C S7500E Series Command Manual

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches Chapter 1 Static Routing Configuration Commands
1-4
Description
Use the ip route-static default-preference command to configure the default
preference for static routes.
Use the undo ip route-static default-preference command to restore the default.
By default, the default preference of static routes is 60.
Note that:
z If no preference is specified when configuring a static route, the default preference
is used.
z When the default preference is re-configured, it applies to newly added static
routes only.
Related commands: display ip routing-table, ip route-static.
Examples
# Set the default preference of static routes to 120.
<Sysname> system-view
[Sysname] ip route-static default-preference 120

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English