H3C S7500E Series

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches Chapter 2 RIP Configuration Commands
2-14
2.1.12 maximum load-balancing
Syntax
maximum load-balancing number
undo maximum load-balancing
View
RIP view
Parameters
number: Maximum number of load balanced routes, in the range 1 to 4.
Description
Use the maximum load-balancing command to specify the maximum number of load
balanced routes in load sharing mode.
Use the undo maximum load-balancing command to restore the default.
By default, the maximum number of load balanced routes is 4.
Examples
# Specify the maximum number of load balanced routes as 2.
<Sysname> system-view
[Sysname] rip
[Sysname-rip-1] maximum load-balancing 2
2.1.13 network
Syntax
network network-address
undo network network-address
View
RIP view
Parameters
network-address: IP address of a network segment, which can be the IP network
address of any interface.
Description
Use the network command to enable RIP on the interface attached to the specified
network.