H3C S7500E Series

Command Manual – Login
H3C S7500E Series Ethernet Switches
Chapter 1 Commands for Logging into an
Ethernet Switch
1-24
Description
Use the stopbits command to set the stop bits of the user interface.
Use the undo stopbits command to revert to the default stop bits.
By default, the stop bits is 1.
 Note:
The stopbits cannot be 1.5 on an S7500E series Ethernet switch.
Examples
# Set the stop bits to 2.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] user-interface aux 0
[Sysname-ui-aux0] stopbits 2
1.1.26 sysname
Syntax
sysname string
undo sysname
View
System view
Parameters
string: System name of the switch. This argument can contain 1 to 30 characters and
defaults to H3C.
Description
Use the sysname command to set a system name for the switch.
Use the undo sysname command to revert to the default system name.
The CLI prompt reflects the system name of a switch. For example, if the system name
of a switch is “H3C”, then the prompt of user view is <H3C>.
Examples
# Set the system name of the switch to ABC.
<Sysname> system-view