H3C S7500E Series Command Manual

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches Chapter 3 OSPF Configuration Commands
3-37
View
OSPF view
Parameters
None
Description
Use the log-peer-change command to enable the logging of OSPF neighbor state
changes.
Use the undo log-peer-change command to disable the logging.
The logging is enabled by default.
With this feature enabled, information about neighbor state changes is displayed on the
terminal until the feature is disabled.
Examples
# Disable the logging of neighbor state changes for OSPF process 100.
<Sysname> system-view
[Sysname] ospf 100
[Sysname-ospf-100] undo log-peer-change
3.1.31 lsa-arrival-interval
Syntax
lsa-arrival-interval interval
undo lsa-arrival-interval
View
OSPF view
Parameters
interval: Specifies the minimum LSA repeat arrival interval in milliseconds, in the range
0 to 60000.
Description
Use the lsa-arrival-interval command to specify the minimum LSA repeat arrival
interval.
Use the undo lsa-arrival-interval command to restore the default.
The interval defaults to 1000 milliseconds.

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English