H3C S7500E Series - Page 346

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches Chapter 3 OSPF Configuration Commands
3-39
Examples
# Configure the maximum LSA generation interval as 2 seconds, minimum interval as
100 milliseconds and incremental interval as 100 milliseconds.
<Sysname> system-view
[Sysname] ospf 100
[Sysname-ospf-100] lsa-generation-interval 2 100 100
3.1.33 lsdb-overflow-limit
Syntax
lsdb-overflow-limit number
undo lsdb-overflow-limit
View
OSPF view
Parameters
number: Specifies the upper limit of external LSAs in the LSDB, in the range 1 to
1000000.
Description
Use the lsdb-overflow-limit command to specify the upper limit of external LSAs in the
LSDB.
Use the undo lsdb-overflow-limit command to cancel the limitation.
External LSAs in the LSDB are unlimited by default.
Examples
# Specify the upper limit of external LSAs as 400000.
<Sysname> system-view
[Sysname] ospf 100
[Sysname-ospf-100] lsdb-overflow-limit 400000
3.1.34 maximum load-balancing
Syntax
maximum load-balancing maximum
undo maximum load-balancing
View
OSPF view