H3C S7500E Series

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches Chapter 4 IS-IS Configuration Commands
4-25
View
IS-IS view
Parameters
flood-count flooding-count: Specifies the maximum number of LSPs to be sent in the
fast-flooding process, ranging from 1 to 15. The default is 5.
max-timer-interval flooding-interval: Specifies the delay interval (in milliseconds)
between when it is enabled and when it begins, ranging from 10 to 50000. The default
is 10.
level-1: Specifies to configure fast-flooding on level-1 only.
level-2: Specifies to configure fast-flooding on level-2 only. If no level is configured, the
fast-flooding will be available on both level-1 and level-2 by default.
Description
Use the flash-flood command to enable IS-IS LSP fast flooding and configure related
parameters, including the maximum number of LSPs to be sent and the delay time
before flooding.
Use the undo flash-flood command to disable fast-flooding.
Fast flooding is disabled by default.
Using this command can speed up LSP flooding that is triggered by topology changes,
so as to reduce LSDB convergence time.
Examples
# Enable fast flooding and configure the maximum LSPs be sent as 10 and the delay
time as 100 milliseconds.
<Sysname> system-view
[Sysname] isis
[Sysname-isis-1] flash-flood flood-count 10 max-timer-interval 100
4.1.21 import-route
Syntax
import-route { isis [ process-id ] | ospf [ process-id ] | rip [ process-id ] | bgp
[ allow-ibgp ] | direct | static } [ cost cost | cost-type { external | internal } | [ level-1
| level-1-2 | level-2 ] | route-policy route-policy-name | tag tag ] *
undo import-route { isis [ process-id ] | ospf [ process-id ] | rip [ process-id ] | bgp |
direct | static }
View
IS-IS view