H3C S7500E Series

Command Manual – Login
H3C S7500E Series Ethernet Switches
Chapter 2 Commands for Controlling
Login Users
2-5
Description
Use the snmp-agent usm-user command to add a user to a specified SNMP group.
You can also optionally use this command to apply an ACL to filter network
management users.
Use the undo snmp-agent usm-user command to remove a user from the
corresponding SNMP group. The operation also frees the user from the corresponding
ACL-related configuration.
Examples
# Add the user named h3c to the SNMP group named h3cgroup, specifying to
authenticate the user, specifying the authentication protocol to be HMAC-MD5-96, the
authentication password to be abc, and applying ACL 2002 to filter network
management users (assuming that ACL 2002 already exists).
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] snmp-agent usm-user v3 h3c h3cgroup authentication-mode md5 abc acl
2002