H3C S7500E Series Command Manual

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches Chapter 5 BGP Configuration Commands
5-34
Description
Use the import-route command to configure BGP to redistribute routes from a
specified routing protocol and advertise redistributed routes.
Use the undo import-route command to disable route redistribution from a routing
protocol.
By default, BGP does not redistribute routes from other protocols.
The ORIGIN attribute of routes redistributed with the import-route command is
incomplete.
Examples
# In BGP view, redistribute routes from RIP.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] import-route rip
5.1.37 log-peer-change
Syntax
log-peer-change
undo log-peer-change
View
BGP view
Parameters
None
Description
Use the log-peer-change command to enable the global BGP logging on peers going
up and down.
Use the undo log-peer-change command to disable the function.
By default, the function is enabled.
Examples
# Enable BGP logging on peers going up and down.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] log-peer-change

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English