To Next Page

To Previous Page

Command Manual – IPv4 Routing

H3C S7500E Series Ethernet Switches Chapter 5 BGP Configuration Commands

5-41

5.1.46 peer connect-interface

Syntax

peer { group-name | ip-address } connect-interface interface-type interface-number

undo peer { group-name | ip-address } connect-interface

View

BGP view

Parameters

group-name: Name of a peer group, a string 1 to 47 characters.

ip-address: IP address of a peer.

interface-type interface-number: Specifies the type and number of the interface.

Description

Use the peer connect-interface command to specify the source interface for

establishing TCP connections to a peer/peer group.

Use the undo peer connect-interface command to restore the default.

Note that:

To establish multiple BGP connections to another BGP router, you need to specify on

the local router the respective source interfaces for establishing TCP connections to the

peers on the peering BGP router; otherwise, the local BGP router may fail to establish

TCP connections to the peers when using the outbound interfaces of the best routes as

the source interfaces.

Examples

# In BGP view, specify loopback 0 as the source interface for routing updates to the

peer group test.

<Sysname> system-view

[Sysname] bgp 100

[Sysname-bgp] peer test connect-interface loopback 0

5.1.47 peer default-route-advertise

Syntax

peer { group-name | ip-address } default-route-advertise [ route-policy

route-policy-name ]

undo peer { group-name | ip-address } default-route-advertise

H3C S7500E Series Command Manual

Other manuals for H3C S7500E Series