H3C S7500E Series Command Manual

Command Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches
Chapter 2 IPv6 RIPng Configuration
Commands
2-3
Description
Use the display ripng command to display the running status and configuration
information of a RIPng process. If process-id is not specified, information of all RIPng
processes will be displayed.
Examples
# Display the running status and configuration information of all configured RIPng
processes.
<Sysname> display ripng
RIPng process : 1
Preference : 100
Checkzero : Enabled
Default Cost : 0
Maximum number of balanced paths : 3
Update time : 30 sec(s) Timeout time : 180 sec(s)
Suppress time : 120 sec(s) Garbage-Collect time : 240 sec(s)
Number of periodic updates sent : 0
Number of trigger updates sent : 0
Table 2-1 Description on the fields of the display ripng command
Field Description
RIPng Process RIPng process ID
Preference RIPng route priority
Checkzero
Whether zero field check for RIPng packet
headers is enabled
Default Cost Default metric of redistributed routes
Maximum number of balanced
paths
Maximum number of load balanced routes
Update time RIPng updating interval, in seconds
Timeout time RIPng timeout interval, in seconds
Suppress time RIPng suppress interval, in seconds
Garbage-Collect time RIPng garbage collection interval, in seconds
Number of periodic updates sent Number of periodic updates sent
Number of trigger updates sent Number of triggered updates sent

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English