Command Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches Chapter 3 IPv6 OSPFv3 Configuration Commands
3-13
Description
Use the display ospfv3 peer command to display OSPFv3 neighbor information.
z If no area-id is specified, the neighbor information of all areas is displayed.
z If no process-id is specified, the information of all processes is displayed.
z If no interface or neighbor Router-ID is specified, the neighbor information of all
interfaces is displayed.
Examples
# Display the neighbor information of OSPFv3 process 1 on an interface.
<Sysname> display ospfv3 1 peer Vlan-interface 400
OSPFv3 Process (1)
OSPFv3 Area (0.0.0.2)
Neighbor ID Pri State Dead Time Interface Instance ID
3.3.3.3 1 Full/Backup 00:00:38 Vlan400 0
Table 3-7 Description on the fields of the display ospfv3 peer command
Field Description
Neighbor ID Neighbor ID
Pri Priority of neighbor router
State Neighbor state
Dead Time Dead time remained
Interface Interface connected to the neighbor
Instance ID Instance ID
# Display detailed neighbor information of OSPFv3 process 1 of an interface.
<Sysname> display ospfv3 1 peer Vlan-interface 400 verbose
OSPFv3 Process (1)
Neighbor: 3.3.3.3, interface address: FE80::2E0:FCFF:FE00:242A
In the area 0.0.0.2 via interface Vlan-interface400
DR is 4.4.4.4 BDR is 3.3.3.3
Options is 0x000011 (-|R|-|-|-|V6)
Dead timer due in 00:00:35
Database Summary List 0
Link State Request List 0
Link State Retransmission List 0
To Next Page
Loading...
Need help?
General
