To Next Page

To Previous Page

Command Manual – IPv6 Routing

H3C S7500E Series Ethernet Switches Chapter 3 IPv6 OSPFv3 Configuration Commands

3-20

Description

Use the display ospfv3 routing command to display OSPFv3 routing table

information.

If no process is specified, routing table information of all OSPFv3 processes is

displayed.

Examples

# Display OSPFv3 routing table information.

<Sysname> display ospfv3 routing

E1 - Type 1 external route, IA - Inter area route, I - Intra area route

E2 - Type 2 external route, * - Seleted route

OSPFv3 Router with ID (1.1.1.1) (Process 1)

------------------------------------------------------------------------

*Destination: 2001::/64

Type : I Cost : 1

NextHop : directly-connected Interface: Vlan100

Table 3-14 Description on the fields of the display ospfv3 routing command

Field Description

Destination Destination network segment

Type Route type

Cost Route cost value

Next-hop Next hop address

Interface Outbound interface

# Display the statistics of OSPFv3 routing table.

<Sysname> display ospfv3 routing statistics

OSPFv3 Router with ID (3.3.3.3) (Process 1)

OSPFv3 Routing Statistics

Intra-area-routes : 1

Inter-area-routes : 1

External-routes : 0

H3C S7500E Series Command Manual

Other manuals for H3C S7500E Series