To Next Page

To Previous Page

Command Manual – IPv6 Routing

H3C S7500E Series Ethernet Switches Chapter 3 IPv6 OSPFv3 Configuration Commands

3-25

bgp4+: Specifies to filter BGP4+ routes.

direct: Specifies to filter direct routes.

static: Specifies to filter static routes.

Description

Use the filter-policy export command to filter redistributed routes.

Use the undo filter-policy export command to remove the configuration.

If no protocol is specified, all redistributed routes will be filtered.

By default, IPv6 OSPFv3 does not filter redistributed routes.

 Note:

Using the filter-policy export command filters only routes redistributed by the

import-route command. If the import-route command is not configured to redistribute

routes from other protocols and other OSPFv3 processes, use of the filter-policy

export command does not take effect.

Examples

# Filter all redistributed routes using IPv6 ACL 2001.

<Sysname> system-view

[Sysname] acl ipv6 number 2001

[Sysname-acl6-basic-2001] rule permit source 2002:1:: 64

[Sysname-acl6-basic-2001] quit

[Sysname] ospfv3

[Sysname-ospfv3-1] filter-policy 2001 export

3.1.19 filter-policy import

Syntax

filter-policy { acl6-number | ipv6-prefix ipv6-prefix-name } import

undo filter-policy import

View

OSPFv3 view

Parameters

acl6-number: Specifies an ACL number, ranging from 2000 to 3999.

H3C S7500E Series Command Manual

Other manuals for H3C S7500E Series