To Next Page

To Previous Page

Command Manual – IPv6 Routing

H3C S7500E Series Ethernet Switches Chapter 3 IPv6 OSPFv3 Configuration Commands

3-37

Examples

# Configure the Router ID as 10.1.1.3 for OSPFv3 process 1.

<Sysname> system-view

[Sysname] ospfv3 1

[Sysname-ospfv3-1] router-id 10.1.1.3

3.1.34 silent-interface

Syntax

silent-interface { interface-type interface-number | all }

undo silent-interface { interface-type interface-number | all }

View

OSPFv3 view

Parameters

interface-type interface-number: Interface type and number

all: Specifies all interfaces.

Description

Use the silent-interface command to disable the specified interface from sending

OSPFv3 packets.

Use the undo silent-interface command to restore the default.

An interface is able to send OSPFv3 packets by default.

Multiple processes can disable the same interface from sending OSPFv3 packets, but

use of the silent-interface command takes effect only on interfaces enabled with the

current process.

Examples

# Disable VLAN-interface 10 from sending OSPFv3 packets in OSPFv3 processes 100

and 200.

<Sysname> system-view

[Sysname] ospfv3 100

[Sysname-ospfv3-100] router-id 10.110.1.9

[Sysname-ospfv3-100] silent-interface vlan-interface 10

[Sysname-ospfv3-100] quit

[Sysname] ospfv3 200

[Sysname-ospfv3-200] router-id 20.18.0.7

[Sysname-ospfv3-200] silent-interface vlan-interface 10

H3C S7500E Series Command Manual

Other manuals for H3C S7500E Series