H3C S7500E Series

Command Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches Chapter 3 IPv6 OSPFv3 Configuration Commands
3-39
Parameters
no-summary: This argument is only applicable to the ABR of a stub area. With it
configured, the ABR advertises only a default route in a Summary-LSA to the stub area
(such an area is called a totally stub area).
Description
Use the stub command to configure an area as a stub area.
Use the undo stub command to remove the configuration.
By default, an area is not configured as a stub area.
When an area is configured as a stub area, all the routers attached to the area must be
configured with the stub command.
Related commands: default-cost.
Examples
# Configure OSPFv3 area 1 as a stub area.
<Sysname> system-view
[Sysname] ospfv3 1
[Sysname-ospfv3-1] area 1
[Sysname-ospfv3-1-area-0.0.0.1] stub
3.1.37 vlink-peer
Syntax
vlink-peer router-id [ hello seconds | retransmit seconds | trans-delay seconds |
dead seconds | instance instance-id ] *
undo vlink-peer router-id [ hello | retransmit | trans-delay | dead ]*
View
OSPFv3 area view
Parameters
router-id: Router ID for a virtual link neighbor.
hello seconds: Specifies the interval in seconds for sending Hello packets, ranging
from 1 to 8192, with the default as 10. This value must be equal to the hello seconds
configured on the virtual link peer.
retransmit seconds: Specifies the interval in seconds for retransmitting LSA packets,
ranging from 1 to 3600, with the default as 5.
trans-delay seconds: Specifies the delay interval in seconds for sending LSA packets,
ranging from 1 to 3600, with the default as 1.