H3C S7500E Series Command Manual

Command Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches Chapter 4 IPv6 IS-IS Configuration Commands
4-2
Examples
# Display IPv6 IS-IS routing information.
<Sysname> display isis route ipv6
Route information for ISIS(1)
-----------------------------
ISIS(1) IPv6 Level-1 Forwarding Table
-------------------------------------
Destination: 2001:: PrefixLen: 64
Flag : R/L/- Cost : 10
Next Hop : Direct Interface: Vlan100
Destination: 2002:: PrefixLen: 64
Flag : R/L/- Cost : 20
Next Hop : FE80::20F:E2FF:FE1D:A65B Interface: Vlan100
Flags: R-Added to RM, L-Advertised in LSPs, U-Up/Down Bit Set
Table 4-1 Description on the fields of the display isis route ipv6 command
Field Description
Destination IPv6 destination address prefix
PrefixLen Length of the prefix
Flag/Flags
Flag of routing information status
D: This is a direct route.
R: The route has been added into the routing table.
L: The route has been advertised in an LSP.
U: Route leaking flag, indicating the Level-1 route is from
Level-2. “UP” means the route will not be returned to Level-2.
Cost Value of cost
Next Hop Next hop
Interface Outbound interface
# Display detailed IPv6 IS-IS routing information.
<Sysname> display isis route ipv6 verbose
Route information for ISIS(1)
-----------------------------
ISIS(1) IPv6 Level-1 Forwarding Table
-------------------------------------
IPV6 Dest : 2001:1::/64 Cost : 10 Flag : R/L/-
Preference : 15 Admin Tag : -

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English