Command Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches Chapter 5 IPv6 BGP Configuration Commands
5-26
5.1.28 import-route
Syntax
import-route protocol [ process-id [ med med-value | route-policy route-policy-name ]
* ]
undo import-route protocol [ process-id ]
View
IPv6 address family view
Parameters
protocol: Redistributes routes from the specified routing protocol, which can be direct,
isisv6, ospfv3, ripng, or static at present.
process-id: Routing protocol process ID, in the range 1 to 65535 and with the default as
1 . It is available only when the protocol is isisv6, ospfv3, or ripng.
med-value: Applies the MED value to redistributed routes. The value is in the range 0 to
4294967295. If not specified, the cost of the redistributed route is used as its MED in
the IPv6 BGP routing domain.
route-policy-name: Name of a routing policy used to filter redistributed routes, a string
of 1 to 19 characters.
Description
Use the import-route command to redistribute routes from another routing protocol.
Use the undo import-route command to remove the configuration.
By default, IPv6 BGP does not redistribute routes from any routing protocol.
The routes redistributed using the import-route command has the incomplete origin
attribute.
Examples
# Redistribute routes from RIPng 1.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv6-family
[Sysname-bgp-af-ipv6] import-route ripng 1
5.1.29 ipv6-family
Syntax
ipv6-family
undo ipv6-family
To Next Page
Loading...
Need help?
General
