Command Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches Chapter 5 IPv6 BGP Configuration Commands
5-30
Description
Use the peer allow-as-loop command to configure IPv6 BGP to allow the local AS
number to exist in the AS_PATH attribute of routes from a peer/peer group, and to
configure the repeating times of the local AS number.
Use the undo peer allow-as-loop command to disable the function.
The local AS number is not allowed to exist in the AS PATH attribute of routes by
default.
Examples
# Configure the repeating times of the local AS number allowed in the AS PATH of
routes from peer 1::1 as 2.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv6-family
[Sysname-bgp-af-ipv6] peer 1::1 allow-as-loop 2
5.1.34 peer as-number
Syntax
peer { ipv6-group-name | ipv6-address } as-number as-number
undo peer ipv6-group-name as-number
undo peer ipv6-address
View
IPv6 address family view
Parameters
ipv6-group-name: Name of a peer group, a string of 1 to 47 characters.
ipv6-address: IPv6 address of a peer.
as-number: AS number of the peer/peer group, in the range 1 to 65535.
Description
Use the peer as-number command to specify an AS number for a peer/peer group.
Use the undo peer as-number command to delete the AS number of a peer group.
Use the undo peer command to delete a peer.
By default, no AS number is configured for a peer/peer group.
Examples
# Specify the AS number of the peer group test as 200.
To Next Page
Loading...
Need help?
General
