Command Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches Chapter 5 IPv6 BGP Configuration Commands
5-33
ipv6-address: IPv6 address of a peer.
interface-type interface-number: Specifies the type and name of the interface.
Description
Use the peer connect-interface command to specify the source interface for
establishing TCP connections to an IPv6 BGP peer or peer group.
Use the undo peer connect-interface command to restore the default.
By default, BGP uses the outbound interface of the best route to the IPv6 BGP
peer/peer group as the source interface for establishing a TCP connection.
Note that:
To establish multiple BGP connections to a BGP router, you need to specify on the local
router the respective source interfaces for establishing TCP connections to the peers
on the peering BGP router; otherwise, the local BGP router may fail to establish TCP
connections to the peers when using the outbound interfaces of the best routes as the
source interfaces.
Examples
# Specify loopback 0 as the source interface for routing updates to peer 1:2::3:4.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv6-family
[Sysname-bgp-af-ipv6] peer 1:2::3:4 connect-interface loopback 0
5.1.38 peer default-route-advertise
Syntax
peer { ipv6-group-name | ipv6-address } default-route-advertise [ route-policy
route-policy-name ]
undo peer { ipv6-group-name | ipv6-address } default-route-advertise
View
IPv6 address family view
Parameters
ipv6-group-name: Name of an IPv6 peer group, a string of 1 to 47 characters.
ipv6-address: IPv6 address of a peer.
route-policy-name: Route-policy name, a string of 1 to 19 characters.
To Next Page
Loading...
