Command Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches Chapter 5 IPv6 BGP Configuration Commands
5-34
Description
Use the peer default-route-advertise command to advertise a default route to a
peer/peer group.
Use the undo peer default-route-advertise command to disable advertising a default
route.
By default, no default route is advertised to a peer/peer group.
Using this command does not require the default route available in the routing table.
With this command used, the router sends the default route unconditionally to the
peer/peer group with the next hop being itself.
Examples
# Advertise a default route to peer 1:2::3:4.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv6-family
[Sysname-bgp-af-ipv6] peer 1:2::3:4 default-route-advertise
5.1.39 peer description
Syntax
peer { ipv6-group-name | ipv6-address } description description-text
undo peer { ipv6-group-name | ipv6-address } description
View
IPv6 address family view
Parameters
ipv6-group-name: Name of a peer group, a string of 1 to 47 characters.
ipv6-address: IPv6 address of a peer.
description-text: Description information for the peer/peer group, a string of 1 to 79
characters.
Description
Use the peer description command to configure the description information for a
peer/peer group.
Use the undo peer description command to remove the description information of a
peer/peer group.
By default, no description information is configured for a peer (group).
You need create a peer/peer group before configuring a description for it.
To Next Page
Loading...
Need help?
General
