H3C S7500E Series - Page 635

Command Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches Chapter 5 IPv6 BGP Configuration Commands
5-35
Examples
# Configure the description for the peer group test as ISP1.
<Sysname] system-view
[Sysname] bgp 100
[Sysname-bgp] ipv6-family
[Sysname-bgp-af-ipv6] group test external
[Sysname-bgp-af-ipv6] peer test description ISP1
5.1.40 peer ebgp-max-hop
Syntax
peer { ipv6-group-name | ipv6-address } ebgp-max-hop [ hop-count ]
undo peer { ipv6-group-name | ipv6-address } ebgp-max-hop
View
IPv6 address family view
Parameters
ipv6-group-name: Name of a peer group, a string of 1 to 47 characters.
ipv6-address: IPv6 address of a peer.
hop-count: Maximum hop count, in the range 1 to 255. By default, the value is 64.
Description
Use the peer ebgp-max-hop command to allow establishing the EBGP connection to a
peer/peer group indirectly connected.
Use the undo peer ebgp-max-hop command to remove the configuration.
By default, this feature is disabled.
You can use the argument hop-count to specify the maximum router hops of the EBGP
connection.
Examples
# Allow establishing the EBGP connection with the peer group test on an indirectly
connected network.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv6-family
[Sysname-bgp-af-ipv6] group test external
[Sysname-bgp-af-ipv6] peer test ebgp-max-hop