H3C S7500E Series

Command Manual – IPv6 Configuration
H3C S7500E Series Ethernet Switches Table of Contents
ii
1.1.37 reset dns ipv6 dynamic-host ...............................................................................1-38
1.1.38 reset ipv6 neighbors............................................................................................ 1-39
1.1.39 reset ipv6 pathmtu............................................................................................... 1-39
1.1.40 reset ipv6 statistics.............................................................................................. 1-40
1.1.41 reset tcp ipv6 statistics........................................................................................ 1-40
1.1.42 reset udp ipv6 statistics....................................................................................... 1-41
1.1.43 tcp ipv6 timer fin-timeout..................................................................................... 1-41
1.1.44 tcp ipv6 timer syn-timeout ................................................................................... 1-42
1.1.45 tcp ipv6 window................................................................................................... 1-42
Chapter 2 Dual Stack Configuration Commands.......................................................................2-1
2.1 Dual Stack Configuration Commands................................................................................ 2-1
2.1.1 ipv6.......................................................................................................................... 2-1
2.1.2 ipv6 address............................................................................................................ 2-1
2.1.3 ipv6 address auto link-local..................................................................................... 2-2
2.1.4 ipv6 address eui-64................................................................................................. 2-3
2.1.5 ipv6 address link-local............................................................................................. 2-3
Chapter 3 Tunneling Configuration Commands ........................................................................ 3-1
3.1 Tunnel Configuration Commands...................................................................................... 3-1
3.1.1 aggregation-group................................................................................................... 3-1
3.1.2 destination............................................................................................................... 3-2
3.1.3 display interface tunnel ...........................................................................................3-3
3.1.4 display ipv6 interface tunnel.................................................................................... 3-4
3.1.5 interface tunnel........................................................................................................ 3-6
3.1.6 mtu (tunnel interface view)......................................................................................3-7
3.1.7 source...................................................................................................................... 3-7
3.1.8 tunnel-protocol.........................................................................................................3-8