H3C S7500E Series

Command Manual – IPv6 Configuration
H3C S7500E Series Ethernet Switches Chapter 3 Tunneling Configuration Commands
3-9
z A proper tunnel type can be selected for packet encapsulation according to the
network topology and application. The same tunnel type must be configured at
both ends of the tunnel. Otherwise, packet delivery will fail.
z Only one automatic tunnel can be configured at the same tunnel source.
Examples
# Specify the tunnel type as IPv6 over IPv4 for a tunnel interface.
<Sysname> system-view
[Sysname] interface tunnel 1/0/3
[Sysname-Tunnel1/0/3] tunnel-protocol ipv6-ipv4