EasyManuals Logo

H3C S7500E Series Command Manual

H3C S7500E Series
1565 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #764 background imageLoading...
Page #764 background image
Command Manual – Multicast
H3C S7500E Series Ethernet Switches Chapter 3 IGMP Configuration Commands
3-8
Related commands: igmp fast-leave, last-member-query-interval.
 Note:
This command takes effect only on Layer 3 interfaces other than VLAN interfaces when
executed in IGMP view.
Examples
# Enable fast leave processing globally.
<Sysname> system-view
[Sysname] igmp
[Sysname-igmp] fast-leave
3.1.6 igmp
Syntax
igmp
undo igmp
View
System view
Parameters
None
Description
Use the igmp command to enter IGMP view.
Use the undo igmp command to remove configurations performed in IGMP view.
IP multicast must be enabled on the device before this command can take effect.
Related commands: igmp enable.
Examples
# Enter IGMP view.
<Sysname> system-view
[Sysname] multicast routing-enable
[Sysname] igmp
[Sysname-igmp]

Table of Contents

Other manuals for H3C S7500E Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the H3C S7500E Series and is the answer not in the manual?

H3C S7500E Series Specifications

General IconGeneral
BrandH3C
ModelS7500E Series
CategorySwitch
LanguageEnglish

Related product manuals