Command Manual – Multicast
H3C S7500E Series Ethernet Switches Chapter 3 IGMP Configuration Commands
3-7
Routing table
Total 2 entries
00001. (*, 225.1.1.1)
List of 1 downstream interface
Vlan-interface1 (20.1.1.1),
Protocol: STATIC
00002. (*, 239.255.255.250)
List of 1 downstream interface
Vlan-interface1 (20.20.20.20),
Protocol: IGMP
Table 3-4 Description on the fields of the display igmp routing-table command
Field Description
00001 Sequence number of this (*, G) entry
(*, 225.1.1.1) An (*, G) entry of the IGMP routing table
List of 1 downstream interface
Downstream interface list, namely the interfaces
to which multicast data for this group will be
forwarded
3.1.5 fast-leave
Syntax
fast-leave [ group-policy acl-number ]
undo fast-leave
View
IGMP view
Parameters
acl-number: Basic ACL number, in the range of 2000 to 2999. If you do not include this
option in your command, this command will take effect for all multicast groups.
Description
Use the fast-leave command to configure fast leave processing globally.
Use the undo fast-leave command to disable fast leave processing globally.
By default, fast leave processing is disabled. Namely, the IGMP querier sends IGMP
group-specific queries upon receiving an IGMP leave message from a host, instead of
sending a leave notification directly to the upstream.