H3C S7500E Series

Command Manual – Multicast
H3C S7500E Series Ethernet Switches Chapter 5 MSDP Configuration Commands
5-11
5.1.9 originating-rp
Syntax
originating-rp interface-type interface-number
undo originating-rp
View
MSDP view
Parameters
interface-type interface-number: Specifies an interface by its type and number.
Description
Use the originating-rp command to configure the address of the specified interface as
the RP address of SA messages.
Use the undo originating-rp command to restore the system default.
Be default, the PIM RP address is used as the RP address of SA messages.
Examples
# Specify the IP address of VLAN-interface 100 as the RP address of SA messages.
<Sysname> system-view
[Sysname] msdp
[Sysname-msdp] originating-rp vlan-interface 100
5.1.10 peer connect-interface
Syntax
peer peer-address connect-interface interface-type interface-number
undo peer peer-address
View
MSDP view
Parameters
peer-address: MSDP peer address.
interface-type interface-number: Specifies an interface by its type and number. The
local device will use the IP address of the specified interface as the source IP address
when setting up a TCP connection with the remote MSDP peer.