Command Manual – 802.1x - MAC Authentication
H3C S7500E Series Ethernet Switches Chapter 1 802.1x Configuration Commands
1-18
Parameters
interface interface-list: Specifies an Ethernet port list, which can contain multiple
Ethernet ports. The interface-list argument is in the format of interface-list =
{ interface-type interface-number [ to interface-type interface-number ] } & <1-10>,
where interface-type represents the port type, interface-number represents the port
number, and & <1-10> means that you can provide up to 10 port indexes/port index lists
for this argument. The start port number must be smaller than the end number and the
two ports must of the same type.
Description
Use the reset dot1x statistics command to clear 802.1x statistics.
With the interface interface-list argument specified, the command clears 802.1x
statistics on the specified ports. With the argument unspecified, the command clears
global 802.1x statistics and 802.1x statistics on all ports.
Related commands: display dot1x.
Examples
# Clear 802.1x statistics on port Ethernet 2/0/1.
<Sysname> reset dot1x statistics interface Ethernet2/0/1
To Next Page
Loading...
Need help?
General
