H3C S7500E Series Command Manual

Command Manual – AAA RADIUS HWTACACS
H3C S7500E Series Ethernet Switches
Chapter 1 AAA/RADIUS/HWTACACS
Configuration Commands
1-21
z lan-access refers to users accessing the network through an Ethernet, such as
802.1x users;
z ssh refers to users using SSH;
z telnet refers to users using Telnet;
z terminal refers to users logging in through the console port or AUX port.
state { active | block }: Specifies all local users in the state of active or block. A local
user in the state of active can access network services, while a local user in the state of
blocked cannot.
user-name user-name: Specifies all local users using the specified username. The
username is a case-sensitive string of 1 to 55 characters.
vlan vlan-id: Specifies all local users in a VLAN. The VLAN ID ranges from 1 to 4094.
slot slot-number: Specifies all local users in the slot where the interface card is
inserted.
Description
Use the display local-user command to display information about specified or all local
users.
Related commands: local-user.
Examples
# Display the information of local user bbb on the card installed on slot 1.
<Sysname> display local-user user-name bbb slot 0
Slot: 0
The contents of local user bbb:
State: Active
ServiceType: lan-access
Idle-cut: Disable
Access-limit: Enable Current AccessNum: 100
Bind location: Disable
Vlan ID: Disable
IP address: Disable
MAC address: Disable
User Privilege: 0
Total 1 local user(s) matched.
Table 1-3 Description on the fields of display local-user (for distributed device)
Field Description
Slot Slot number of the card
State Status of the local user, active or block

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English