Command Manual – AAA RADIUS HWTACACS
H3C S7500E Series Ethernet Switches
Chapter 1 AAA/RADIUS/HWTACACS
Configuration Commands
1-31
Parameters
active: Places the current ISP domain or local user in the active state, allowing the
users in the current ISP domain or the current local user to request network services.
block: Places the current ISP domain or local user in the blocked state, preventing
users in the current ISP domain or the current local user from requesting network
services.
Description
Use the state command to configure the status of the current ISP domain or local user.
By default, an ISP domain is active when created. So does a local user.
By blocking an ISP domain, you disable users of the domain that are offline from
requesting network services. Note that the online users are not affected.
By blocking a user, you disable the user from requesting network services. No other
users are affected.
Related commands: domain.
Examples
# Place the current ISP domain aabbcc.net to the state of blocked.
<Sysname> system-view
[Sysname] domain aabbcc.net
[Sysname-isp-aabbcc.net] state block
# Place the current user user1 to the state of blocked.
<Sysname> system-view
[Sysname] domain aabbcc.net
[Sysname-user-user1] state block
1.1.32 work-directory
Syntax
work-directory directory-name
undo work-directory
View
Local user view
Parameters
directory-name: Name of the directory that FTP/SFTP users are authorized to access,
a case-insensitive string of 1 to 135 characters.
To Next Page
Loading...
Need help?
General
