Command Manual – AAA RADIUS HWTACACS
H3C S7500E Series Ethernet Switches
Chapter 1 AAA/RADIUS/HWTACACS
Configuration Commands
1-57
1.2.25 timer realtime-accounting
Syntax
timer realtime-accounting minutes
undo timer realtime-accounting
View
RADIUS scheme view
Parameters
minutes: Real-time accounting interval in minutes, must be a multiple of 3 and in the
range 3 to 60, with the default value being 12.
Description
Use the timer realtime-accounting command to set the real-time accounting interval.
Use the undo timer realtime-accounting command to restore the default.
Note that:
z For real-time accounting, a NAS must transmit the accounting information of
online users to the RADIUS accounting server periodically. This command is for
setting the interval.
z The setting of the real-time accounting interval somewhat depends on the
performance of the NAS and the RADIUS server: a shorter interval requires
higher performance. You are therefore recommended to adopt a longer interval
when there are a large number of users (more than 1000, inclusive). The
following table lists the recommended ratios of the interval to the number of
users.
Table 1-6 Recommended ratios of the accounting interval to the number of users
Number of users Real-time accounting interval (minute)
1 to 99 3
100 to 499 6
500 to 999 12
1000 or more 15 or more
Related commands: retry realtime-accounting, radius scheme.
Examples
# Set the real-time accounting interval to 51 minutes for RADIUS scheme radius1.
<Sysname> system-view
To Next Page
Loading...
Need help?
General
