H3C S7500E Series Command Manual

Command Manual – AAA RADIUS HWTACACS
H3C S7500E Series Ethernet Switches
Chapter 1 AAA/RADIUS/HWTACACS
Configuration Commands
1-74
View
HWTACACS scheme view
Parameters
None
Description
Use the stop-accounting-buffer enable command to enable the device to buffer
stop-accounting requests getting no responses.
Use the undo stop-accounting-buffer enable command to disable the device from
buffering stop-accounting requests getting no responses.
By default, the device is enabled to buffer stop-accounting requests getting no
responses.
Since stop-accounting requests affect the charge to users, a NAS must make its best
effort to send every stop-accounting request to the HWTACACS accounting servers.
For each stop-accounting request getting no response in the specified period of time,
the NAS buffers and resends the packet until it receives a response or the number of
transmission retries reaches the configured limit. In the latter case, the NAS discards
the packet.
Related commands: reset stop-accounting-buffer, hwtacacs scheme, display
stop-accounting-buffer.
Examples
# In HWTACACS scheme hwt1, enable the device to buffer the stop-accounting
requests getting no responses.
<Sysname> system-view
[Sysname] hwtacacs scheme hwt1
[Sysname-hwtacacs-hwt1] stop-accounting-buffer enable
1.3.18 timer quiet
Syntax
timer quiet minutes
undo timer quiet
View
HWTACACS scheme view

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English