Command Manual – AAA RADIUS HWTACACS
H3C S7500E Series Ethernet Switches
Chapter 1 AAA/RADIUS/HWTACACS
Configuration Commands
1-75
Parameters
minutes: Primary server quiet period, in minutes. It ranges from 1 to 255 and defaults to
5.
Description
Use the timer quiet command to set the quiet timer for the primary server, that is, the
duration that the status of the primary server stays blocked before resuming the active
state.
Use the undo timer quiet command to restore the default.
Related commands: display hwtacacs.
Examples
# Set the quiet timer for the primary server to 10 minutes.
<Sysname> system-view
[Sysname] hwtacacs scheme hwt1
[Sysname-hwtacacs-hwt1] timer quiet 10
1.3.19 timer realtime-accounting
Syntax
timer realtime-accounting minutes
undo timer realtime-accounting
View
HWTACACS scheme view
Parameters
minutes: Real-time accounting interval in minutes. It is a multiple of 3 in the range 3 to
60 and defaults to 12.
Description
Use the timer realtime-accounting command to set the real-time accounting interval.
Use the undo timer realtime-accounting command to restore the default.
Note that:
z For real-time accounting, a NAS must transmit the accounting information of
online users to the HWTACACS accounting server periodically. This command is
for setting the interval.
z The setting of the real-time accounting interval somewhat depends on the
performance of the NAS and the HWTACACS server: a shorter interval requires
higher performance. You are therefore recommended to adopt a longer interval
To Next Page
Loading...
Need help?
General
