To Next Page

To Previous Page

Command Manual – RRPP

H3C S7500E Series Ethernet Switches Chapter 1 RRPP Configuration Commands

1-7

If you have specified an RRPP ring ID in the command, the detailed information of the

specified ring in the specified RRPP domain appears. Otherwise, the detailed

information of all the rings in the specified RRPP domain appears.

Examples

# Display the detailed information of ring 1 in RRPP domain 1.

<Sysname> display rrpp verbose domain 1 ring 1

Domain ID : 1

Control VLAN : Major 5 Sub 6

Hello Timer : 1 sec Fail Timer : 3 sec

Ring ID : 1

Ring Level : 1

Node Mode : Master

Ring State : Complete

Enable Status : Yes Active Status: Yes

Primary port : GigabitEthernet3/0/1 Port status: UP

Secondary port: GigabitEthernet3/0/2 Port status: BLOCKED

# Display the detailed information of all the rings in RRPP domain 2.

<Sysname> display rrpp verbose domain 2

Domain ID : 2

Control VLAN : Major 10 Sub 11

Hello Timer : 1 sec Fail Timer : 3 sec

Ring ID : 1

Ring Level : 0

Node Mode : Master

Ring State : Complete

Enable Status : Yes Active Status: Yes

Primary port : GigabitEthernet3/0/4 Port status: UP

Secondary port: GigabitEthernet3/0/5 Port status: BLOCKED

Ring ID : 2

Ring Level : 1

Node Mode : Edge

Ring State : -

Enable Status : No Active Status: No

Common port : GigabitEthernet3/0/4 Port status: -

Edge port : GigabitEthernet3/0/3 Port status: -

H3C S7500E Series Command Manual

Other manuals for H3C S7500E Series