H3C S7500E Series Command Manual

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches Chapter 5 BGP Configuration Commands
5-3
5.1.2 balance
Syntax
balance number
undo balance
View
BGP view
Parameters
number: Number of BGP routes for load balancing. Its range varies with devices. When
it is set to 1, load balancing is disabled.
Description
Use the balance command to configure the number of BGP routes for load balancing.
Use the undo balance command to disable load balancing.
By default, no load balancing is configured.
Unlike IGP, BGP has no explicit metric for making load balancing decision. Instead, it
implements load balancing using route selection rules.
Related commands: display bgp routing-table.
Examples
# In BGP view, set the number of routes participating in BGP load balancing to 2.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] balance 2
5.1.3 bestroute as-path-neglect
Syntax
bestroute as-path-neglect
undo bestroute as-path-neglect
View
BGP view
Parameters
None

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English