Command Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches
Chapter 2 IPv6 RIPng Configuration
Commands
2-9
[Sysname-ripng-100] filter-policy ipv6-prefix Filter1 import
2.1.9 import-route
Syntax
import-route protocol [ process-id ] [ allow-ibgp ] [ cost cost | route-policy
route-policy-name ] *
undo import-route protocol [ process-id ]
View
RIPng view
Parameters
protocol: Specifies a routing protocol from which to redistribute routes. Currently, it can
be bgp4+, direct, isisv6, ospfv3, ripng, or static.
process-id: Process number of the specified routing protocol, in the range of 1 to 65535,
with the default as 1. This argument is available only when the routing protocol is isisv6,
ospfv3, or ripng.
cost: Routing metric of redistributed routes, in the range of 0 to 16. If cost value is not
specified, the metric is the default metric specified by the default cost command.
route-policy route-policy-name: Specifies a routing policy by its name with 1 to 19
characters.
allow-ibgp: Optional keyword when the specified protocol is bgp4+. The import-route
bgp4+ command redistributes only EBGP routes. The import-route bgp4+
allow-ibgp command redistributes additionally IBGP routes, thus be cautious when
using it.
Description
Use the import-route command to redistribute routes from another routing protocol.
Use the undo import-route command to disable redistributing routes from another
routing protocol.
By default, RIPng does not redistribute routes from other routing protocols.
z You can configure a routing policy to redistribute only needed routes.
z You can specify a cost for redistributed routes using keyword cost.
Related commands: default cost.
Examples
# Redistribute IPv6-IS-IS routes (process 7) and specify the metric as 7.
<Sysname> system-view
[Sysname] ripng 100
To Next Page
Loading...
Need help?
General
