H3C S7500E Series Command Manual

Command Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches
Chapter 2 IPv6 RIPng Configuration
Commands
2-10
[Sysname-ripng-100] import-route isisv6 7 cost 7
2.1.10 maximum load-balancing
Syntax
maximum load-balancing number
undo maximum load-balancing
View
RIPng view
Parameters
number: Maximum number of equal-cost load-balanced routes. Its value is in the range
1 to 4.
Description
Use the maximum load-balancing command to specify the maximum number of
equal cost routes for load balancing.
Use the undo maximum load-balancing command to restore the default.
By default, the maximum number of equal cost routes for load balancing is 4.
 Note:
Configure the maximum number according to the memory size.
Examples
# Set the maximum number of load balanced routes with equal cost to 2.
<Sysname> system-view
[Sysname] ripng 100
[Sysname-ripng-100] maximum load-balancing 2
# Restore the default.
[Sysname-ripng-100] undo maximum load-balancing
2.1.11 preference
Syntax
preference [ route-policy route-policy-name ] preference
undo preference [ route-policy ]

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English