H3C S7500E Series

Command Manual – VLAN
H3C S7500E Series Ethernet Switches Chapter 1 VLAN Configuration Commands
1-18
Examples
# Associate the Hybrid port Ethernet 2/0/1, with protocol 0 in VLAN 2.
<Sysname> system-view
[Sysname] vlan 2
[Sysname-Vlan2] protocol-vlan at
[Sysname] interface ethernet 2/0/1
[Sysname-Ethernet2/0/1] port link-type hybrid
[Sysname-Ethernet2/0/1] port hybrid vlan 2 untagged
Please wait... Done
[Sysname-Ethernet2/0/1] port hybrid protocol-vlan vlan 2 0
1.3.4 protocol-vlan
Syntax
protocol-vlan [ protocol-index ] { at | ipv4 | ipv6 | ipx { ethernetii | llc | raw | snap } |
mode { ethernetii etype etype-id | llc { dsap dsap-id [ ssap ssap-id ] | ssap ssap-id } |
snap etype etype-id } }
undo protocol-vlan { protocol-index [ to protocol-end ] | all }
View
VLAN view
Parameters
at: Specifies the AppleTalk based VLAN.
ipv4: Specifies the IPv4 based VLAN.
ipv6: Specifies the IPv6 based VLAN.
ipx: Specifies the IPX based VLAN. The keywords ethernetii, llc, raw, and snap are
encapsulation formats.
mode: Configures self-defined protocol template for the VLAN, which could also have
four encapsulation formats, namely, ethernetii, llc, raw, and snap.
ethernetii etype etype-id: Specifies to match Ethernet II encapsulation format and the
corresponding protocol type values. The etype-id argument is the Ethernet type of
inbound packets, in the range 0x0600 to 0xffff (excluding 0x0800, 0x809b, 0x8137, and
0x86dd).
llc: Specifies the encapsulation format for Ethernet packets to be llc.
dsap dsap-id: Specifies the destination service access point, in the rang 00 to ff.
ssap ssap-id: Specifies the source service access point, in the rang 00 to ff.
snap etype etype-id: Specifies to match SNAP encapsulation format and the
corresponding protocol type values. The etype-id argument is the Ethernet type of