Command Manual – 802.1x - MAC Authentication
H3C S7500E Series Ethernet Switches Chapter 1 802.1x Configuration Commands
1-5
interface-type represents the port type, interface-number represents the port number,
and & <1-10> means that you can provide up to 10 port indexes/port index lists for this
argument. The start port number must be smaller than the end number and the two
ports must of the same type.
Description
Use the dot1x command in system view to enable 802.1x globally.
Use the undo dot1x command in system view to disable 802.1x globally.
Use the dot1x interface interface-list command in system view or the dot1x command
in interface view to enable 802.1x for specified ports.
Use the undo dot1x interface interface-list command in system view or the undo
dot1x command in interface view to disable 802.1x for specified ports.
By default, 802.1x is neither enabled globally nor enabled for any port.
Note that:
z 802.1x must be enabled both globally in system view and for the intended ports in
system view or interface view. Otherwise, it does not function.
z You can configure 802.1x parameters either before or after enabling 802.1x.
Related commands: display dot1x.
Examples
# Enable 802.1x for ports Ethernet 2/0/1, and Ethernet 2/0/5 to Ethernet 2/0/7.
<Sysname> system-view
[Sysname] dot1x interface Ethernet2/0/1 Ethernet2/0/5 to Ethernet2/0/7
Or
<Sysname> system-view
[Sysname] interface Ethernet2/0/1
[Sysname-Ethernet2/0/1] dot1x
[Sysname-Ethernet2/0/1] quit
[Sysname] interface Ethernet2/0/5
[Sysname-Ethernet2/0/5] dot1x
[Sysname-Ethernet2/0/5] quit
[Sysname] interface Ethernet2/0/6
[Sysname-Ethernet2/0/6] dot1x
[Sysname-Ethernet2/0/6] quit
[Sysname] interface Ethernet2/0/7
[Sysname-Ethernet2/0/7] dot1x
# Enable 802.1x globally.
<Sysname> system-view
[Sysname] dot1x
To Next Page
Loading...
Need help?
General
