Command Manual – AAA RADIUS HWTACACS
H3C S7500E Series Ethernet Switches
Chapter 1 AAA/RADIUS/HWTACACS
Configuration Commands
1-39
time-range start-time stop-time: Specifies a time range by its start time and end time in
the format of hh:mm:ss-mm/dd/yyyy or hh:mm:ss-yyyy/mm/dd.
user-name user-name : Specifies a user by the user name, which is a case-sensitive
string of 1 to 80 characters.
slot slot-number: Specifies the slot where the interface card is inserted.
Description
Use the display stop-accounting-buffer command to display information about the
stop-accounting requests buffered in the device by scheme, session ID, time range,
user name, or slot.
Note that if receiving no response after sending a stop-accounting request to a RADIUS
server, the device buffers the request and retransmits it. You can use the retry
stop-accounting command to set the number of allowed transmission attempts.
Related commands: reset stop-accounting-buffer, stop-accounting-buffer enable,
retry stop-accounting.
Examples
# Display information about the buffered stop-accounting requests from 0:0:0 to
23:59:59 on August 31, 2006.
<Sysname> display stop-accounting-buffer time-range 0:0:0-08/31/2006
23:59:59-08/31/2006
Total find 0 record (0)
1.2.5 key
Syntax
key { accounting | authentication } string
undo key { accounting | authentication }
View
RADIUS scheme view
Parameters
accounting: Sets the shared key for RADIUS accounting packets.
authentication: Sets the shared key for RADIUS authentication/authorization packets.
string: Shared key, a case-sensitive string of 1 to 16 characters.
Description
Use the key command to set the shared key for RADIUS authentication/authorization
or accounting packets.
To Next Page
Loading...
Need help?
General
