Command Manual – DHCP
H3C S7500E Series Ethernet Switches Chapter 1 DHCP Server Configuration Commands
1-19
By default, no WINS server address is specified.
If you use the nbns-list command repeatedly, the latest configuration will overwrite the
previous one.
Related commands: dhcp server ip-pool, netbios-type.
Examples
# Specify WINS server address 10.12.1.99 in DHCP address pool 0.
<Sysname> system-view
[Sysname] dhcp server ip-pool 0
[Sysname-dhcp-pool-0] nbns-list 10.12.1.99
1.1.23 netbios-type
Syntax
netbios-type { b-node | h-node | m-node | p-node }
undo netbios-type
View
DHCP address pool view
Parameters
b-node: Broadcast node. A b-node client sends the destination name in a broadcast
message. The destination returns the name-to-IP mapping to the client after receiving
the message.
p-node: Peer-to-peer node. A p-node client sends the destination name in a unicast
message to the WINS server, and the WINS server returns the mapping to the client.
m-node: Mixed node, a combination of a b-node first and p-node second. An m-node
client broadcasts the destination name, if there is no response, and then unicasts the
destination name to the WINS server to get the mapping.
h-node: Hybrid node, a combination of a p-node first and b-node second. An h-node is
a p-node with the peer-to-peer communication mechanism. An h-node client unicasts
the destination name to the WINS server, if there is no response, and then broadcasts it
to get the mapping from the destination.
Description
Use the netbios-type command to specify the client NetBIOS node type in a DHCP
address pool.
Use the undo netbios-type command to remove the client NetBIOS node type
assigned from a DHCP address pool to the DHCP client.
By default, no NetBIOS node type is specified.
To Next Page
Loading...
Need help?
General
