Telit Wireless Solutions LE910C series At Commands Reference Guide

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 101 of 1904 2022-03-04
Not Subject to NDA
3.1.18. AT+CVHU - Voice Hung Up Control
This command is used in order to set how to disconnect a voice connection.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Required
Specific profile
No
-
2
AT+CVHU=[<mode>]
Set command selects whether ATH or "drop DTR" shall cause a voice
connection to be disconnected or not.
Parameter:
Name
Type
Default
Description
<mode>
integer
2
Selects how to disconnect a voice
connection.
Values:
0
:
"Drop DTR" ignored but OK result code given. ATH
disconnects.
1
:
"Drop DTR" and ATH ignored but OK result code given.
2
:
"Drop DTR" behavior according to &D setting. ATH
disconnects.
OK result code is displayed only when using UART depending on
the model.
AT+CVHU?
Read command reports the current value of the <mode> parameter, in the
format:
+CVHU: <mode>

Telit Wireless Solutions LE910C series Specifications

General

Brand	Telit Wireless Solutions
Model	LE910C series
Category	Wireless modules
Language	English