Telit Wireless Solutions LE910C series - AT#ACAL - Automatic Call

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 73 of 1904 2022-03-04
Not Subject to NDA
3.1.4. AT#ACAL - Automatic Call
Automatic Call.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Specific profile
No
-
2
AT#ACAL=[<mode>]
Set command enables/disables the automatic call function.
Parameter:
Name
Type
Default
Description
<mode>
integer
0
disables or enables the automatic call
function
Values:
0
:
disable the automatic call function
1
:
enable the automatic call function
Additional info:
<mode>=1
If the automatic call function is enabled, and &D2 command has
been issued, the transition OFF/ON of DTR causes an automatic call
to the first number (position 0) stored in the internal phonebook.
Type of call depends on the last issue of command +FCLASS.
See &Z and &N commands respectively to write or read the phone
number on/from the internal phonebook of the module.